All right YouTube, here it is, the ultimate
pipe cleaning guide.
No mess, no bags, no microwave, no boiling on the stove, nothing like that.
Very simple, very effective.
I really like this method.
First you want to seal off
the bowl, and any other holes that might be on the pipe like carbs,
or anything like that. I’m using electrical
tape. You don’t have to but it
works very well, it doesn’t leak if you wrap it correctly,
and most people have it laying around… but I’ve used plastic wrap
in the past and other things…
but anyway, you want to completely seal off the
pipe like i’m doing here.
I’m going to speed it up just a bit here… and next we’re going to grab some kosher salt.
(just press that in and make sure
everything is all
I’m going to use kosher salt here, you don’t have to.
If you just have regular salt you can use that too, but kosher salt is a more effective scrubbing agent.
You don’t want it completely
packed full, you want room for
your solvent as well, which we’ll add in a second…
If you end up with too much salt in there just knock a bit of it back out.
I’m using 100% pure acetone.
You can also use nail polish remover
or rubbing alcohol, but pure acetone is the best, it work like magic.
As with the salt, you don’t want it completely full of acetone.
You want some air in there, maybe about twenty percent.
You want your cleaning solution to be able to move freely and move around…
so leave a little air in there. We’re going to finish sealing off the pipe.
Make sure it’s completely sealed up,
And then you’re going to shake, shake, shake, shake!
If you clean your pipe on a regular basis you can get away with two or three minutes, and it will be clean.
If it’s REALLY funky,
I’ve had to shake up to ten minutes. It just depends on how much
use the pipe has gotten.
Shake shake shake! also I just want to
make a little note: I’ve seen a lot of videos here on YouTube where people are putting
alcohol and salt into a bag
and they’re kind of missing the point. The
point of the salt is that it doesn’t
Read How To Grow Cannabis Indoors In Containers Want This For Free?
dissolve in the solvent and remains a good scrubbing agent. You want that on the inside of the pipe
How To Grow Cannabis Indoors In Containers Want This For Free? Today
That’s why I like to sealing it off like
I do in this method.
… also you’ll notice I already had the water running before I rinse it out, because
you want it to be nice and hot when you use it first, you don’t want to wait for it to heat up.
I’m going to manually scrub out the bowl here
because you’ll usually have a couple little bits and pieces left in there,
it doesn’t get a lot of flow…
but the insides are already perfect.
I’m going to give it one little quick
rinse here with acetone, one more time, just to get rid of anything that may have redeposited
on the inside of the pipe when I put the water in there.
Give it one more hot water rinse, make sure you have all the residue out and it is just clean water.
Dry it off. I’m going to bring it back over to the light source so you can see how we did…
BOOM! Clean pipe, like the day it was blown.